| Info: | |
| Data type: |
Description:
The "selection of node number via software" function allows the user to set the node number used for an ACOPOS in the application via a specific software protocol instead of using the node number switch provided on the ACOPOS hardware. On all ACOPOS modules for which this function is to be applied, the same node number must be set on the node number switch.
For the CAN network, this unique node number can be defined in an NC deployment table (NC mapping table) via the NC object type "ncMANAGER" using the XML attribute "NodeNr_SwNodeSelect".
If an ACOPOS module is configured with this unique node number, this error is displayed.
Reaction:
Initialization of the NC software is aborted. No NC object can be operated.
Cause/Remedy:
Do not configure an ACOPOS module with that node number, which is defined with "NodeNr_SwNodeSelect".