| Info: | |
| Data type: |
Description:
Runtime error while monitoring the holding brake controller. The minimum permissible holding brake output voltage was exceeded during the filter time BRAKE_CTRL_MON_FILTER. Module-dependent limit values can be found in the user's manual.
Reaction:
See error number 6029.
Cause/Remedy:
Wiring: Excessive voltage drop between the auxiliary supply module's 24V output and the holding brake output of the inverter module. -> Use multiple expansion modules, cable cross-sections
8B0C: The DC supply to the auxiliary supply module is less than 315VDC
8B0C: The 24V output of the auxiliary supply module is defective -> Replace module
8B0C: Overloaded module -> Use larger module or an additional module
8BVI: Faulty holding brake controller or voltage monitor -> Replace module
8DI, 80V: The parameter MOTOR_BRAKE_VOLT_REL is set to a too large value.