IMM A5 Manual

Option: Steam Interface (04A450)

General The Steam Interface is used to control the steaming device. Injection and Mold Open interlocks can be configured. Mold […]

General The Code Box allows the creation and configuration of up to four individual programs.Each program defines logical conditions that

1. Purpose To clearly guide service engineers on differences in program configurations by CPU type when using IMC400-based monitors, and

Richard Wagner / February 19, 2026

🌐 Language Note: Die englische Version dieser Dokumentation finden Sie im unteren Abschnitt der Seite. / The English version of

The Extended Buttons Panel is a physical control panel consisting of up to nine buttons and one spring-loaded rotary knob.

Overview This document describes the Tie-Bar Retraction Device for an Injection Moulding Machine. The function is intended exclusively for tool

A new page has been added to support the tuning of relevant controllers (Drive Speed Controller, Minimum Pressure Controller, Injection

Sanghoon Kim / January 22, 2026

1. Overview Its primary purpose is to prevent Overcurrent Alarms and subsequent motor shutdowns that can occur when the servo

A platform-independent application for online connection to B&R PLCs to monitor process variables. Deployment Note: Future machine images will have

tobias.stuetz / December 4, 2025

Clamp General Parameter Value Range Description Sensor Type SSI Actuator Type Hydraulic Minimum Stroke 0.0 mm Maximum