Option: Air Valve Good/Bad Part Separation (03A201)
This device ensures that parts classified as good or bad based on various measurement data from the machine are automatically […]
IMM A5 Manual
IMM A5 Manual
IMM A5, IMM A5 Manual
Machine Setup Parameters (TE-A5, IMC510)
Clamp Parameter Value Range Description General– Sensor Type– Actuator Type– 1st Step Release Pressure– End Release Pressure– Maximum Sensor Pressure–
IMM A5, IMM A5 Manual
Option: Spring Mold (DLA5)
In DL models, when the mold closing process is performed using two pumps, an issue can occur after the mold
IMM A5 Manual
Machine Setup Parameters DL650A5
1. Servo-Pump The basic settings I have tried. Servo-Pump 1 has the Kp 0.99 and the Tn 0.010, exactly the
IMM A5, IMM A5 Manual
Option: Predictive Grease Level Monitoring (08A060)
The predictive grease level system calculates how much grease has been discharged, shows the remaining volume, and warns operators before
IMM A5, IMM A5 Manual
Option: Cavity Pressure Sensor (07A441)
1. Machine Option 2. User Settings (Injection / Cavity Pressure Settings page) 2.1 Cavity Pressure Settings 2.1.1 Cavity Pressure Settings
IMM A5, IMM A5 Manual
Option: HotWater Unit (06A746)
This function is used to interface with an additional Hot Water Unit (mold temperature control unit).At the moment, this option
IMM A5 Manual, IMM A5
Option: Degasing (03A303)
The Degassing Function is typically used after injection to remove residual gas, moisture, or to enable foaming inside the mold.
IMM, IMM A5, IMM A5 Manual
[IMC400]Dynamic Hardware Configuration Manual
1. Screen Click Dynamic Hardware Configuration on the maintenance page. 2. Configuration 3. Adding Cards (Manual Setting) Example:Default Card +
IMM A5 Manual, How-to-Guides Linux, A5 Maintenance Manual
Rotate Screen on Linux
Note: This setup is only applicable for linux image versions >=9.When a new image is installed on the HMI PC,