Option: Air Valve Good/Bad Part Separation (03A201)
This device ensures that parts classified as good or bad based on various measurement data from the machine are automatically […]
IMM A5 Manual
IMM A5
IMM A5 Firmware IMC5xx, Uncategorized
Smart Sequencer Diagnosis step number
To quickly identify the exact step the Smart Sequencer is currently in when it has problems, an additional diagnostic section
IMM A5 Manual, IMM A5
Machine Setup Parameters (TE-A5, IMC510)
Clamp Parameter Value Range Description General– Sensor Type– Actuator Type– 1st Step Release Pressure– End Release Pressure– Maximum Sensor Pressure–
IMM, Safetey PLC A5, IMM A5
A5 safety PLC
Name Machine series Release Date A5_1_13 DLA5 THA5TEA5 25-07-2025 TLA5_1_03 TLA5 20-11-2024 SFV_1.07 SFV1800 SFV2400 08-03-2023 VH_3 VHARS, VHLRS 13-06-2025
IMM A5 Manual, IMM A5
Option: Spring Mold (DLA5)
In DL models, when the mold closing process is performed using two pumps, an issue can occur after the mold
IMM A5 Manual
Machine Setup Parameters DL650A5
1. Servo-Pump The basic settings I have tried. Servo-Pump 1 has the Kp 0.99 and the Tn 0.010, exactly the
IMM A5 Manual, IMM A5
Option: Predictive Grease Level Monitoring (08A060)
The predictive grease level system calculates how much grease has been discharged, shows the remaining volume, and warns operators before
IMM A5 Manual, IMM A5
Option: Cavity Pressure Sensor (07A441)
1. Machine Option 2. User Settings (Injection / Cavity Pressure Settings page) 2.1 Cavity Pressure Settings 2.1.1 Cavity Pressure Settings
IMM A5 Manual, IMM A5
Option: HotWater Unit (06A746)
This function is used to interface with an additional Hot Water Unit (mold temperature control unit).At the moment, this option
IMM A5, IMM A5 Manual
Option: Degasing (03A303)
The Degassing Function is typically used after injection to remove residual gas, moisture, or to enable foaming inside the mold.