[TEA5] Safe Toggle Release Function
1. Overview Its primary purpose is to prevent Overcurrent Alarms and subsequent motor shutdowns that can occur when the servo […]
IMM A5 Manual, IMM A5, IMM
IMM A5 Manual
Option: Air Valve Good/Bad Part Separation (03A201)
This device ensures that parts classified as good or bad based on various measurement data from the machine are automatically
IMM A5 Manual, IMM A5
Machine Setup Parameters (TE-A5, IMC510)
Clamp Parameter Value Range Description General– Sensor Type– Actuator Type– 1st Step Release Pressure– End Release Pressure– Maximum Sensor Pressure–
IMM A5 Manual, IMM A5
Option: Spring Mold (DLA5)
In DL models, when the mold closing process is performed using two pumps, an issue can occur after the mold
IMM A5 Manual, IMM A5
Option: Predictive Grease Level Monitoring (08A060)
The predictive grease level system calculates how much grease has been discharged, shows the remaining volume, and warns operators before
IMM A5 Manual, IMM A5
Option: Cavity Pressure Sensor (07A441)
1. Machine Option 2. User Settings (Injection / Cavity Pressure Settings page) 2.1 Cavity Pressure Settings 2.1.1 Cavity Pressure Settings
IMM A5 Manual, IMM A5
Option: HotWater Unit (06A746)
This function is used to interface with an additional Hot Water Unit (mold temperature control unit).At the moment, this option
IMM A5 Manual, IMM A5
Option: Degasing (03A303)
The Degassing Function is typically used after injection to remove residual gas, moisture, or to enable foaming inside the mold.
KEBA, Drive
KEBA D3 drive control unit configuration
2. The configuration screen appears as shown below. I will explain each section that needs to be configured. 1) Unit settings.
IMM, IMM A5 Manual, IMM A5
Option: Lubrication (Greasing) (08A050 ~ 08A055)
Option Selection on Fixdata This page allows the user to configure lubrication (greasing) settings for different parts of the machine.